Beam RST825 SatRADIO Manuel d'installation

Portable Satellite and Radio Communications System RST825 SatRADIO Beam Communications Pty. Ltd.

Page 10 of 30 Using RST825 SatRADIO The RST825 is a fully self contained standalone portable Radio over Iridium Satellite system in a rugged carry c

Page 11 of 30 Getting Started The RST825 requires that a valid Iridium or Telstra Mobile Satellite SIM card to be installed. This is not included i

Page 12 of 30 RST825 Connector Overview Connecting the Antenna Cable Plug the antenna cable into the TNC antenna jack located on the front ri

Page 13 of 30 RST825 Operation System Power up After installation has been completed, the RST825 system is now ready to be switched on. To turn o

Page 14 of 30 The Satellite module provides the air interface to allow two-way radio systems to interface to either another Beam SatRADIO terminal o

Page 15 of 30 3. End the call by pressing C on the Intelligent Handset. NOTE: The call cannot be terminated from a radio if it was originated or a

Page 16 of 30 8. Hanging up the call: If the call was manually dialed or was incoming, it can be hung-up by the handheld user by simply pressing t

Page 17 of 30 Setting up Autodial feature The Auto-dial switch indicates to the SatRADIO that a number is to be auto-(re)dialed once the Radio is tu

Page 18 of 30 VOX operation – Understanding the operation Once the voice call is in progress, the base operator can hear all traffic on the Radio ch

Page 19 of 30 Installing the Antenna - refer to separate guide See the specific “Iridium Antenna Guide” or visit www.beamcomm.net Intelligent Hand

Page 2 of 30 User and Installation Manual SatRADIO RST825 User and Installation Manual Version 3 Beam Communications Pty Ltd 8 Anzed Court

Page 20 of 30 Data Communications A 9 pin serial communications DATA port is provided for data communications over the Iridium satellite channel. Da

Page 21 of 30 Internal RS232 Port Signal Support and Handshaking On the Data port, DCD and DSR output signals are related to DTR input and CTS is ti

Page 22 of 30 Troubleshooting This chapter provides information to help you troubleshoot problems you may encounter while running the RST825. Q No

Page 23 of 30 Q Your SIM card won’t work. A Is the card inserted the correct way? Is the gold chip visibly damaged or scratched? Return the card to

Page 24 of 30 Configuration – Technical Notes Configuration of the SatRADIO can be performed by a user with sufficient privileges, and is usually r

Page 25 of 30 SRM9000 2 Way Radio Programming • Programming of the radio operating frequencies and personalities of the SRM9000 two way radio modu

Page 26 of 30 Radio (SRM9000 Transceiver) Frequency range (sub-bands) 136MHz to 174MHz, 403-480MHz, 440-520MHz Channel Spacing 10 / 12.5 / 20 / 2

Page 27 of 30 BEAM Warranty Conditions BEAM Communications gives this express warranty (along with extended warranty endorsements, where applicable

Page 28 of 30 Appendix: SRM9000 2 Way Radio Operator Card (courtesy TMC Radio Pty Ltd) See following 2 pages.

Page 3 of 30 Package Contents The RST825 package contents  1 x Rugged Case enclosure  1 x RST820 unit – including Iridium transceiver (internal) 

Page 30 of 30

Page 4 of 30 User information  Please record your serial number here for future reference: Model: BEAM RST825 Serial no.:  This num

Page 5 of 30 Contents PACKAGE CONTENTS ...

Page 6 of 30 Safety Information IMPORTANT! Please read the following information carefully before installing and using this BEAM equipment. Fai

Page 7 of 30 Exposure to Radio Frequency Signals Your wireless mobile telephone is a low power radio transmitter and receiver. When it is ON, it rec

Page 8 of 30 About BEAM Communications BEAM Communications, is an authorised manufacturer of Iridium Satellite products. BEAM deve

Page 9 of 30 About your RST825 SatRADIO The RST825 is a Portable Radio over Satellite system providing standalone battery-backed communications for